| Repeated Insertion and Withdrawal | Insertion and withdrawal actuator up to 20 cycles at the speed rate of less than 10 cycles/minute. (No power) | Contact Resistance: 60 m MAX |
| Temperature Rise | Carrying rated current load. (UL 498) | Temperature Rise: 30 MAX |
| Vibration | DC 1mA energized; vibration along XYZ three axes; Amplitude: 1.5mm P-P; Sweep time: 10-55-10Hz/minute; Duration: 2 hours in each X, Y, Z axes. | Appearance: No Damage
Contact Resistance: 60 m MAX
Discontinuity: 1 ms MAX |
| Shock | DC 1mA energized; along 6 mutually perpendicular directions; 490m/s {50G} shock; 3 times each. | Appearance: No Damage
Discontinuity: 1 ms MAX |
| Heat Resistance | Mate applicable FPC/FFC; place in 852 air for 96 hours; then return to room temperature for 1-2 hours. | Appearance: No Damage
Contact Resistance: 60 m MAX |
| Cold Resistance | Mate applicable FPC/FFC; place in -402 air for 96 hours; then return to room temperature for 1-2 hours. | Appearance: No Damage
Contact Resistance: 60 m MAX |
| Humidity | Mate applicable FPC/FFC; place in 402, 90-95% RH air for 96 hours; then measure within 0.5 hours after returning to room temperature. | Appearance: No Damage
Contact Resistance: 60 m MAX
Dielectric Strength: Must meet 4.1.3
Insulation Resistance: 20 M MIN |
| Temperature Cycling | Mate applicable FPC/FFC; 5 cycles of: a) -553 for 30 minutes; b) 852 for 30 minutes; with 10-15 minutes at room temperature and humidity between cycles. | Appearance: No Damage
Contact Resistance: 60 m MAX |
| Salt Spray | Mate applicable FPC/FFC; 484 hours exposure to a salt spray from 51% solution at 35 2. Wash with room temperature water after test; then dry at room temperature. | Appearance: No Damage, No Corrosion
Contact Resistance: 60 m MAX |
| SO2 Gas Resistance | Mate applicable FPC/FFC; 24 hours exposure to 505ppm SO2 gas at 402. | Contact Resistance: 60 m MAX |
| NH3 Gas Resistance | Mate applicable FPC/FFC; 40 minutes exposure to NH3 gas evaporating from 28% Ammonia solution. | Appearance: No Damage
Contact Resistance: 60 m MAX |
| Solderability | Dip the terminal tip 0.2mm from the reference plane into a tin bath at 2355 for 20.5 sec. | Solder Wetting: 95% coverage |
| Resistance to Soldering Heat | Dip the terminal tip 0.2mm from the reference plane into a tin bath at 2605 for 50.5 sec. | Appearance: No Damage, No Deformation |
